Comtest-networks NID-01V POTS Splitter Datajack Manuel d'utilisateur télécharger pdf

SA-4504-0002 Rev 3.0 1 of 2 May 24, 2011

Residential NID-01V POTS Splitter Datajack Installation Guide

Comtest Networks

Application

The NID-01V splitter is required to provide xDSL signal separation from the voice line within the customer’s residence.

Preparation

The NID-01V does not require an earth ground.

Only use 22AWG, 24AWG or 26AWG solid conductor type for the installation.

An electrical box depth of 1-7/8, or greater, is required for this installation.

Instructions

Assemble two (2) Datajack connectors with the wire

length shown. These will be used for the Modem and

Phone connections. Maintain wire twist at all times.

Snip off the NID top mounting tab.

Pull each IDC towards you, until it swings open and

stops.

The NID-01V has three connectors:

• Modem – customer’s xDSL modem.

• Line – the incoming line.

• Phone - customer’s telephone

Each IDC connector can accommodate only one pair

of wires.

If the wire has been previously used, cut-off

approximately ½” from the end, before inserting into

the IDC connectors on the NID-01V.

Mounting tab

removed

IDC

Incoming Line

To xDSL Modem

To Phone

3”

1 2

SA-4504-0002 Rev 3.0 2 of 2 May 24, 2011 With approximately 3” of wire slack, connect the incoming line wire to the Line Port on the NID-01V. Conne

Pas de commentaire

Comtest-networks NID-01V POTS Splitter Datajack Manuel d'utilisateur