Comtest-networks NID-01VTJ POTS Splitter Manuel d'utilisateur télécharger pdf (Page 2)

SA-4700-0001 Rev A.1 2 of 2 November 30, 2011

The NID-01VTJ has four connections:

 Modem – customer’s xDSL modem

 Line – the incoming line

 Phone - customer’s telephone

 Test Jack – verify connection to central office

If the wires have been previously used, cut-off

approximately ½” from the end, before inserting into

the IDC (Insulation Displacement Connector) on the

NID-01VTJ.

Making IDC connections:

Push each IDC away from you, until it swings open

and stops.

Carefully observe the proper orientation of the Tip-

Ring leads. Do not remove the insulation from

the wire and maintain the wire twist. Insert each

pair of wires into the appropriate IDC about ½”.

Press the IDC closed, until the IDC latches lock into

place. It will take some force to close the IDC, with

the thicker wire gauges taking more effort.

Testing

To test the NID-01VTJ for correct operation, connect a phone to the phone jack and lift the handset - you should

hear dial tone.

The modem status light should be illuminated indicating xDSL service. You may have to refer to the xDSL modem

users guide to correctly interpret the meaning of its status indicators.

Once tested, secure the wires.

Warranty

The NID-01VTJ is covered by a 3-year warranty under normal operating conditions. Defective units should be returned to

Comtest Networks where they will be replaced or repaired and returned to the user. The NID-01VTJ contains no user

serviceable parts. Opening the plastic housing voids the warranty and may expose the user to hazardous voltages.

For Assistance

techhelp@comtestnetworks.com

1- 877-369-5499

www.comtestnetworks.com

Test Access Jack

Incoming Line

To xDSL Modem

To Phone

1 2

Pas de commentaire

Comtest-networks NID-01VTJ POTS Splitter Manuel d'utilisateur Page 2